Stock / cheap / sell 【controlled brushless motor starters (Figure)] - factory direct scope of application of the power supply voltage: three-phase 50Hz 380V-10KV applicable motor: three-phase winding asynchronous motor starter frequency: an hour of not more than 10 times Altitude: no more than 2000M Ambient temperature: minimum temperature of -25 ° C, the maximum temperature of +40 ° C non-flammable, and explosive, the severe corrosive gases are the main technical parameters 1, Rated voltage: 380V, 6KV, 10KV, with Motor power :130-2000KW. 2, starting characteristics: a. Light load: 0.6Me b contained: 1Me c overloaded: 1.5Me3 motor constant torque, constant current starter, starting current, starting torque according to user requirements, continuously stepless adjustment. 4, wound motor brushless run completely eradicate the use of slip rings, carbon brushes caused harm, save costs by 70% starting control cabinet and secondary cables wound motor starter, running The maintenance workload reduced by 90%, improve the reliability of the motor and control unit more than doubled. Installation and wiring 1, first remove the shield of the motor, slip ring, carbon brushes, brush box, brush box bracket and short-circuit ring device (some motor short-circuit loop device) and all parts. 2, removing the slip ring, to prevent the subsequent wiring error occurs, the two conductors of the same phase should be tied. 3, with a vernier caliper, measure the motor shaft diameter and pore size of the starter, key width is the same key to higher dimensions, if any difference with the Company in a timely manner, in order to solve. 4 coated little grease or oil on the shaft keyway aligned with the axis of the starter key position, then the starter Tongbang gently tap to the assembled position, and is stuck with a wire retaining ring, to prevent the starter axially moving string. Assembly and avoid Luanqiao Cookin, so as to avoid damage to the internal parts or leaking. After completion of the starter assembly, the corresponding position of the outlet of the rotor is connected to the terminal of the starter (for a motor with six outlet, should the two conductors of the same phase, connected to the two terminals of the same color), in particular wiring as shown below. Operation and maintenance of a controlled brushless motor soft starter components in addition to resistance at the start may have a fever, the other will not heat, the device according to the maintenance-free design, do not own the cover open, so as not to damage the starter within elements. 2, when the the starter liquid below the specified liquid level, should complement starter fluid to the provisions of liquid level. 3, safety exhaust valve is to ensure that the motor was not out important parts of the spray liquid motor speed to reach the rated speed, it will open automatically to ensure consistent pressure and atmospheric pressure within the starter, so, please do not The self-adjusting. The Ordering Information JR JZR YR YZR series motor size is not uniform design and production due to the slip ring at the size of the manufacturer, the parameter slightly Participation different. This user ordering motor nameplate data, manufacturers and motor use, in order to ensure a successful installation. Controlled brushless motor soft starter is starting resistance is directly mounted on the motor shaft, the use of the motor rotation when production