Zhejiang temperature and light WZR controlled brushless motor soft starter manufacturers Scope Supply Voltage: three-phase 50Hz 380V-10KV applicable motor: three-phase wound rotor induction motor start-up frequency: more than 10 times per hour Altitude: less than 2000M Ambient temperature: minimum temperature of -25 ° C, maximum temperature of +40 ° C non-flammable, explosive, no serious corrosive gas main technical parameters 1, Rated voltage: 380V, 6KV, 10KV, Motor power :130-2000KW . 2, starting characteristics: a light load: 0.6Me (b) contained: 1Me c overloaded: 1.5Me3, motor constant torque, constant current start, starting current, starting torque according to user requirements, continuous stepless adjustment. 4, wound brushless motor running, the complete eradication of the use of slip rings, the hazards caused by the carbon brush, saving 70% less expensive starter control cabinet and the second cable, the the wound motor starting device, run 90% reduction in maintenance workload, improve the reliability of motor and control device more than doubled. Installation and wiring, first remove the motor shroud, slip ring, carbon brushes, brush box, brush box bracket and short circuit ring device (some motor short-circuit ring device), and all other parts. Demolition of slip ring, to prevent later wiring errors, the same two wires should be tied together. 3, with a vernier caliper, measure the motor shaft diameter and pore size of the starter, key pitch, the key to higher dimensions are the same, if any difference, with the company in a timely manner, in order to solve. Lightly grease or oil on the shaft keyway alignment of the starter shaft key, and then copper rod starter gently tap to the assembly position, and stuck with a wire ring to prevent starter axial move. 5, assembly, should not knocking Cookin, so as to avoid damage to internal parts or leaking. After the completion of the initiator assembly, the outlet of the rotor is connected in the starter terminal corresponding to the position (there are six outlet of the motor, the two wires should be of the same phase, connected to the two terminals of the same color) can be specific wiring as shown below. Operation and maintenance, brushless motor soft starter components in addition to resistance in the start-up may have a fever, the other will not heat, the device is maintenance-free design, please do not own the cover open, so as not to damage the starter within elements. 2, when the starter liquid is less than a predetermined liquid level, should be added to the required starting fluid liquid level. 3, safety exhaust valve is to ensure that the motor was not an important component of the liquid jet out it to reach the rated speed as the motor will automatically open with the atmospheric pressure inside the starter, so users do not self-adjustment. Ordering Information JR, JZR, YR, YZR series motors are not uniform due to the size of the slip ring at design production, the size of each manufacturer's parameters parameters slightly different. Order for this user should be provided when the motor nameplate data, manufacturers and motor use, in order to ensure a successful installation. Brushless motor soft starter is the starting resistor mounted directly on the motor shaft, the motor rotating the